Vicon V1400X-DVC-3 Spécifications télécharger pdf (Page 12)

•

••

•

Installation XX017-01-00 Rev 702 V1400X-IDL Intelligent Distribution Line Control

1. Fabricate the RS-422 protocol cable as

described above. It is recommended to label

both cable ends.

2. Connect the Master Keypad end (open

wires) of the cable to the Screw Terminal

Block (J1) on the Keypad, as shown in

Figure 5.

3. Press the 6-position Terminal Block end of

the cable into the STAT 1/J1 connector.

4. (Optional) Connect Slave Keypads as

described in Vicon Installation and Operation

Manual X777.

5. Connect additional cables to consecutive

Station connectors (2, 3, 4, etc.).

NOTE: All unused station (STAT) port Terminal

Blocks are terminated with an end-of-line jumper.

Remove this small wire between the Response

In - signal (Pin 5) and Ground (Pin 4) when using

the port.

Figure 5

STAT 1 (J1) - STAT 10 (J10) Pin Definition for

V1300X-DVC/RVC Cable

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

Pas de commentaire

Vicon V1400X-DVC-3 Spécifications Page 12