Vicon VDR-408 Manuel d'utilisateur télécharger pdf (Page 4)

Virtual Matrix Display Controller Connecttion and Setup Guide | 3

General

This manual describes how to connect and setup the Virtual Matrix Display

Controller. The VMDC can be purchased as a tower or rack-mount style with

1, 2 or 3 video cards installed, each of which can drive two monitors (1 VGA

and 1 DVI, 1 VGA and 1 HDMI or 1 DVI and 1 HDMI), for a result of 2, 4 or 6

display outputs (monitors). Each monitor can then potentially display up to 64

video streams (see specification for actual display capabilities).

The VMDC is meant to be used with the V1500X-SCCS System Controller, if

a CCTV keypad is required.

Installation

The VMDC has up to 3 factory-installed display cards. Each of the cards has

three monitor outputs, one VGA connector (blue), one HDMI connector

(black) and one DVI connector (white); only two monitors can be connected

to each card. If there is more than one display card, the monitors must be

connected in the proper order; it is suggested that if used, the DVI connection

be made first. Refer to the Figure that follows.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Vicon VDR-408 Manuel d'utilisateur Page 4