Vicon Kollector Pro Manuel d'utilisateur télécharger pdf

TECH NOTE

VICON TECHNICAL SERVICES GROUP

Subject: ViconNet Kollector PATA - HDD

Replacement - Procedure

Product: KE KP KN

Number: 1400-0001-87-02

Date: 4/26/2007

This document will cover the replacement and setup of a hard disk drive (HDD) in the ViconNet Kollector.

Replacement HDD’s should always be Vicon approved. This document applies to Kollectors using IDE drives

only on the KE, KP & KN. Installation of the Windows Embedded OS for the Kollectors and ViconNet is covered

in separate documentation. HDD replacement requires a specific installation sequence. Each step is dependent

on the other. Basic PC hardware knowledge and Windows configuration is suggested.

Replacing the drive is not difficult, but requires careful attention when removing and installing the hard drive,

configuration in Windows and ViconNet storage database setup. HDD in Kollectors usually follow a drive letter

and label / name convention in Windows. C: Embedded E: DB-1 F: DB-2 G: DB-3- Sometimes external RAID storage is

used and may display as E: RAID-1, F: RAID-2

NOTE: This procedure does not cover Serial ATA drives or Kollectors configured for internal RAID storage

What you’ll need.

o Tools suitable for PC servicing.

o PS 2 keyboard, Mouse, Monitor.

o The new HDD drive.

o OS disk J2 or K if replacing the OS drive

o ViconNet 2.x and ptz driver

o USB Thumb drive

Overview. Below is the installation sequence; A view of a Kollector from the top and a typical hdd drive

arrangement. **Please observe TIPS, NOTES and Cautions for the things to watch out for **

Installation Sequence Kollector from top Older Kollector

Typical HDD layout

Newer Series Kollector Drive Layout seen from inside from the rear

HDD0= C:\OS drive XP OS

CD-RW= D:\ CDROM Read-Write

Pre-Installation

checks before

replacing HDD

Removing &

Installing HDD

Bios Checks

OS Setup

of the

HDD

ViconNet Setup

and Operaton

Checks

Post Hard Drive

Replacement

Checks

Power

supply

Drive Cage

Front of Kollector

HDD1= E:\ DB-1 Data Hard Drive

HDD2= F:\DB-2 Data Hard Drive

HDD3= G:\DB-3 Data Hard Drive

HDD4= H:\DB-4 Data Hard Drive

Kollector Elite sn 3xxxx

Edited 4/20/2007 –add Hitachi HDD Page 1 of 11

Kollector Pro sn 3xxxx

1 2 3 4 5 6 ... 10 11

TECH NOTE 1